CCNA Routing and Switching

Cisco Certified Network Associate Routing and Switching (CCNA R/S)

Cisco Certified Network Associate (CCNA) Routing and Switching is a certification program for entry-level network engineers that helps maximize your investment in foundational networking knowledge and increase the value of your employer's network.

 0%

Question 1 of 10

1. You have four RSTP PVST+ links between switches and want to aggregate the bandwidth. What solution will you use?

Question 1 of 10

Question 2 of 10

2. Which of the following commands provides the product ID and serial number of a router?

Question 2 of 10

Question 3 of 10

3. What configuration parameters must be configured the same between switches for LACP to form a channel? (Choose three.)

Question 3 of 10

Question 4 of 10

4. You reload a router with a configuration register setting of 0x2101. What will the router do when it reloads?

Question 4 of 10

Question 5 of 10

5. Which command allows you to view the technology options and licenses that are supported on your router along with several status variables?

Question 5 of 10

Question 6 of 10

6. You need to connect to a remote IPv6 server in your virtual server farm. You can connect to the IPv4 servers, but not the critical IPv6 server you desperately need. Based on the following output, what could your problem be?

C:\>ipconfig
Connection-specific DNS Suffix . : localdomain
IPv6 Address. . . . . . . . . . . :2001:db8:3c4d:3:ac3b:2ef:1823:8938
Temporary IPv6 Address. . . . . . :2001:db8:3c4d:3:2f33:44dd:211:1c3d
Link-local IPv6 Address . . . . . : fe80::ac3b:2ef:1823:8938%11
IPv4 Address. . . . . . . . . . . : 10.1.1.10
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 10.1.1.1

Question 6 of 10

Question 7 of 10

7. When is the AVR router used in GLBP?

Question 7 of 10

Question 8 of 10

8. What is the sys-id-ext field in a BPDU used for?

 

Question 8 of 10

Question 9 of 10

9. Which of the following will you use to collect details about network traffic patterns on your network, including protocols used.

 

Question 9 of 10

Question 10 of 10

10. You want to send a console message to a syslog server, but you only want to send status messages of 3 and lower. Which of the following commands will you use?

 

Question 10 of 10


 

Skriv kommentar

Din e-mailadresse vil ikke blive publiceret. Krævede felter er markeret med *